Skip to main content
LOW EMISSION · 46,000 kW (160MM BTU/hr)

Coal-Water Slurry Fired Thermal Fluid Heater

  • Fuel Type: Coal-Water Slurry (Clean Oil-Substitute Liquid Fuel)
  • Heat Medium: Premium Thermal Oil (Organic Heat Carrier)
  • Heat Output: 1,800 - 46,000 kW (6 - 160 MM BTU/hr)
Coal-water slurry fired thermal fluid heater with 6MM–160MM BTU/hr capacity

Overview

The CEEF Coal-Water Slurry Fired Thermal Fluid Heater (coal-water slurry thermal oil heater and hot oil heater) fires an advanced, clean oil-substitute liquid fuel—coal-water slurry (formulated from ultra-fine coal powder, 27–35% water, and 1% dispersant additive). With fluidity similar to heavy fuel oil, it supports pipeline pumping and atomized burner firing, achieving over 90% combustion efficiency (far exceeding conventional grate-fired raw coal). Using thermal oil driven by high-temperature circulation pumps in a forced liquid-phase closed loop, the system delivers stable high-temperature process heat at low operating pressure—combining the economy of coal with the convenience and cleanliness of liquid fuel.

Key Features

  • High-Efficiency Energy-Saving Design: Full-process energy-saving thermal design refined over 48 years of thermal engineering experience.
  • Multi-Radiant Section Furnace Architecture: Optimized combustion chamber geometry paired with multi-radiant section heating coils.
  • Expansive Radiant Heating Surface: Generous radiant heating surface area ensures rapid, complete absorption of atomized flame heat.
  • Reinforced Convective Heat Transfer: High-efficiency convective tube bank arrangement dramatically lowers exhaust flue gas heat loss.
  • Automated Multi-Directional Soot Blowing: Equipped with an automated, multi-directional online soot-blowing and ash-cleaning system to prevent fouling and ash accumulation on heating surfaces.
  • Precision Flue Gas Temperature Control: Advanced closed-loop temperature control at the furnace throat and furnace exit.
  • Intrinsic Explosion Protection: Integrated auto-reset explosion-relief doors safeguard furnace operation under all conditions.
  • Strict Environmental Compliance: Paired with multi-stage high-efficiency dust collection and desulfurization purification systems to meet stringent emission regulations.
  • Comprehensive Flue Gas Waste Heat Recovery: Integrates tail-end flue gas heat recovery equipment (air preheater or waste heat boiler).
  • Automated Combustion Interlock Control: Highly automated air-fuel ratio interlock control and optimized system configuration.

Direct Factory Engineering

Get a Custom Quote & Datasheet

Tell our thermal engineers your operating temperature, heat load, and available fuel. We will size the right Coal-Water Slurry Fired Thermal Fluid Heater configuration and reply within 24 hours.

  • ASME S & U Stamp, ISO 9001 & CCS Marine certified fabrication
  • Sized with proprietary thermal calculation software (40+ years IP)
  • Direct from the Changzhou manufacturer — no trading middlemen

Prefer email? Write to contact@ceef.com

← Back to All Products

Send Your Project Requirements

Inquiring about
Coal-Water Slurry Fired Thermal Fluid Heater

By submitting, you agree to our Privacy Policy. We never share your data with third parties.