Skip to main content
ULTRA-LOW NOX GAS · OVERLOAD CAPABLE · 46,000 kW (46 MW)

Gas-Fired Thermal Oil Heater

  • Fuel Type: Natural Gas / City Gas / LPG (Ultra-Low NOx Emissions)
  • Key Tech: Auto-Reset Explosion Door & Quick-Open Inspection Structure
  • Heat Output: 180~46,000 kW (615k~160MM BTU/hr)
Ultra-low NOx gas-fired thermal oil heater with auto-reset explosion door

The CEEF Gas-Fired Thermal Oil Heater (horizontal gas-fired hot oil heater and thermal fluid heater) is a highly automated, eco-friendly industrial heating system delivering operating temperatures up to 350°C and single-unit outputs up to 46,000 kW (46 MW / 160MM BTU/hr), engineered to meet the most stringent domestic and international environmental emission standards.

Key Features:

  • Ultra-Low NOx Combustion & Environmental Control: Purpose-built for clean gaseous fuels, integrating advanced Ultra-Low NOx burners with a full PLC automated control system for complete combustion and verified emission compliance.
  • Overload Heating Capability: Optimized thermodynamic and fluid-dynamic design allows the thermal oil heater to effortlessly handle periodic overload heat demands during production peaks without sacrificing temperature accuracy or coil service life.
  • Advanced Multi-Layer Coil Architecture: Employs double- or multi-layer closely pitched radiant coils plus a roof coil configuration to optimize furnace volumetric heat intensity and reinforce convective heat transfer.
  • Effortless Maintenance & Intrinsic Safety: Features a quick-open furnace door structure that drastically shortens inspection and maintenance downtime, paired with auto-reset explosion-relief door technology for long-cycle operational safety.
  • Maximized Thermal Efficiency: Combines reinforced composite insulation with tail-end flue gas waste heat recovery units to minimize heat loss and substantially lower daily fuel operating costs.

Direct Factory Engineering

Get a Custom Quote & Datasheet

Tell our thermal engineers your operating temperature, heat load, and available fuel. We will size the right Gas-Fired Thermal Oil Heater configuration and reply within 24 hours.

  • ASME S & U Stamp, ISO 9001 & CCS Marine certified fabrication
  • Sized with proprietary thermal calculation software (40+ years IP)
  • Direct from the Changzhou manufacturer — no trading middlemen

Prefer email? Write to contact@ceef.com

← Back to All Products

Send Your Project Requirements

Inquiring about
Gas-Fired Thermal Oil Heater

By submitting, you agree to our Privacy Policy. We never share your data with third parties.